Add automatic tests in TestPlan for minimum gas:
- Copy minimum gas result (pressure) to diveplan.
- Add cylinder size and working pressure for bottom gas to every dive in TestPlan
Hint: Unrealistic cylinder sizes (100l, 200l) have to be used for the very long and deep dives in TestPlan
- Add minimum gas check for every dive
- Add two additional test dives in TestPlan which produce sane minimum gas results with 24l tank
Hint: Deco check for these new dives is commented out at the moment
Signed-off-by: Stefan Fuchs <sfuchs@gmx.de>
If variables were accidentally carried through from a previous calculated plan,
subsequent plan could be affected. This test aims to detect if this happens.
Commit 8994270 corrected such a bug. If it were reverted, this test would fail
(as it should).
Signed-off-by: Rick Walsh <rickmwalsh@gmail.com>
Signed-off-by: Dirk Hohndel <dirk@hohndel.org>
Add more VPM-B planner tests. The "expected" total run time is taken as the
total run time produced by the Fortran VPM-B program. For all these tests, the
results are within two minutes, which is a good result, but most are classified
as a "fail".
Signed-off-by: Rick Walsh <rickmwalsh@gmail.com>
Signed-off-by: Dirk Hohndel <dirk@hohndel.org>
This adds a test for 100 m for 60 min dive on trimix using VPM-B
Signed-off-by: Rick Walsh <rickmwalsh@gmail.com>
Signed-off-by: Dirk Hohndel <dirk@hohndel.org>
This sets up a standard dive scenario (30 minutes at 260ft/79m, EAN36 and
Oxygen as deco gases, last stop at 20ft/6m) and calls the planner to set
up a dive plan given certain standard gases.
Instead of trying to verify the complete plans it checks that we switch to
the deco gases at the right depth and the complete duration of the dive
matches our expectation.
The test intentionally fails right now for imperial as we have the wrong
switch depth for Oxygen. See how useful tests are?
On the downside, the test does NOT produce the same plan as Subsurface
when I try to create a consistent setup for both - and I have not been
able to figure out why. There must be some other parameters that I'm not
setting, but I haven't identified them, yet. It's very small differences,
for example in the metric case the stops at 21m, 9m, and 6m are each one
minute shorter in the test than it what Subsurface calculates.
Signed-off-by: Dirk Hohndel <dirk@hohndel.org>
